UW-Stout/Hydrogen Peroxide SP22

Introduction

Hydrogen Peroxide (H2O2) is a very strong oxidizer and antiseptic that is often used in dilute forms. The overall compound is found in biological systems but is in short lived reactions due to it's high toxicity over time. The goal of our experiment was to test how multiple yeast strains with knockout genes would respond in the presence of varying concentrations of hydrogen peroxide.

Materials

• Hydrogen Peroxide Solution 3% Concentration

• Distilled water for dilutions

• Wild Type and Knockout Yeast Strains

Equipment

• P-200 Micropipette
• P-20 Micropipette
• P-10 Micropipette
• Centrifuge Tubes
• Yeast Test Well

Calibration Protocol

H2O2 Dilutions

1. Vortex yeast strains
2. Create 50ul Hydrogen Peroxide dilutions as required
3. Mix dilutions With 50ul yeast strains
4. Place mixtures in individual wells on a lab plate to grow For 24 hours

Calibration Trial 1 Percent Series: 3%, 1%, 0.3%, 0.1%, 0.03%, 0.01%

Interpretation

Based on the calibration experiment, we determined that the concentration of hydrogen peroxide tested on the yeast would need to be much lower if we wanted to see consistent amounts of inhibition and compare them. The higher concentrations in the experiment yielded data was too close among the wells, so based on the calibration we settled on a dilution of 0.065%, as the range of 0.03% to 0.1% seemed to show the most observable differences in data.

Knockout Protocol

Procedure

1. Vortex yeast strains
2. Create 50ul Hydrogen Peroxide dilutions for final solutions of 0.065% concentrations (one for each strain)
3. Mix dilutions With 50ul yeast strains
4. Place mixtures in individual wells on a lab plate to grow for 24 hours
5. Place standard controls of each strain (50ul yeast mixed with 50ul of water) in individual wells on a lab plate to grow for 24 hours as comparison
6. Plot growth data.